New updates to racing setup

I had a few days off and spent some time working on my racing rig.

 I got my shifter mounted to the playseat. I bolted two brackets together, drilled out the wholes so a 1/4 inch bolt would fit through and bolted it all to the shifter plate. The cable that plugs into the shifter goes on the bottom of it, so I either had to create something that elevated it a couple of inches or mount it offset the way I did.

I also added the seat slider to the playseat so I can get my old ass in and out a little easier.

Then I got a few bed risers to elevate the table the monitors are on. I was going to build something out of wood, this was much easier and didn't cost much at all. While I had the drill out I went ahead and hard mounted the wheel.

The last thing I did was hard mount the pedals to the playseat. A few more minutes with the drill and I was able to bolt the pedals to a steel plate, then bolted the plate to the playseat.

Here's a video I made explaining how it all works.